The new FBG Hayabusa Ignition comes complete ready to bolt on.  The Hayabusa Ignition is compatible with Dyna2000, Schnitz Pro Series II and MSD. This billet aluminum housing is similar to the previous model, but on this one, the trigger plate is on the outside of the engine. You can change the timing just like a GS1100. The timing marks are stamped on the included rotor, you do not need a degree wheel or a dial indicator, just bolt in on and you're ready to go.

You do not have to run carbs to use this plate, you can add them later.  Just use the coil dummies listed below, and you can use your factory fuel systems.

Features:

• Low cost
• Now you can run carburetors
• External Timing adjustment (in seconds)
• Very easy installation (bolt on)
• Extra strength and support for starter gear (no more broken covers)
• Aftermarket ignition fixes shift problems
• No more trigger plate running in oil
• Comes with all instructions, with photos
• Comes with bolt, seal, everything you need.

It's available several different ways:

• Just the complete housing with cover, rotor, bolt and seal (If you have your own trigger plate)
• Complete housing, trigger plate w/2 magnet rotor
• Complete housing, trigger plate w/1 magnet rotor and Dyna 2000 Ignition
• Complete housing, trigger plate w/2 magnet rotor, Pro Series II and THE .7ohm coils.
• Complete houseing, trigger plate, rotor, MC-4 Box and coils & wires